Installation instruc tio ns – Poison Spyder JK BRAWLER LITE FRONT SKID PLATE User Manual
Page 3
INSTALLATION INSTRUC
TIO
NS
©2013 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
Poison Spyder Customs • JK BRAWLER LITE FRONT SKID PLATE
Page 3
Once these marks have been made, remove
the bumper and skid plate. Note that bolting
to the crash bar is considered optional, and its
omission will not be a considerable detriment
to the bumper/skid structural integrity.
9. Use the drill motor and 3/8” bit to drill the five
holes along the bottom of the crash bar that
were located and marked in the preceding
step.
10. De-burr the edges of the holes then use
touch-up paint or clear coat to protect the
bare metal.
11. Proceed with the remainder of the front
bumper installation procedure. If using the
option to bolt to the crash bar, use the four
(4) supplied 3/8-16 X 1 Gr8 Hex Head Cap
Screws, along with 3/8 X 1 Fender Washers
and 3/8-16 Gr8 Nylon Insert Lock Nuts to bolt
through the bottom of the Brawler Lite Skid
Plate, into the crash bar.
Congratulations, you have completed the
installation of your Poison Spyder JK Front
Brawler Lite Skid Plate! Now, please proceed
with the remaining instructions to complete the
installation of your JK Brawler Lite Front Bumper.