Installation instruc tio ns – Poison Spyder JK BFH REAR BUMPER User Manual

Page 2

INSTALLATION INSTRUC

TIO

Poison Spyder Customs • JK BFH REAR BUMPER INSTALL

Page 2

5. Drill the two new hole locations (one on

each frame rail) that were marked with the

cut templates. Use the 1/4” bit to drill the

pilot holes, then finish with the 1/2” bit.

6. Apply primer and paint to the bare metal in

the areas where you cut, grinded and drilled.

Properly coating these areas at this time will

help to prevent rust in the future.

7. Install the supplied clip nuts into each

frame rail. Slip the clip nut through the

existing oval-shaped hole in the frame rail

and lodge the threaded portion of the clip nut

into the 1/2” hole that was drilled. Make sure

the extruded side of the clip nut is oriented

toward the inside of the frame rail and the

flush side of the clip nut is along the exterior

surface of the frame rail.

8. Place the BFH Bumper on to the frame rails.

Use the supplied hardware to attach the

bumper at each location where a clip nut was

installed in step 8. Use previously-removed

OE hardware for the other two bolt locations

on either side (through the holes marked

“EXISTING HOLE” on the cut templates).

Make sure the bumper is properly aligned as

you tighten these bolts.

Congratulations, you have installed your Poison

Spyder Customs BFH front bumper!