Poison Spyder TJ BFH II REAR BUMPER - Manual (Page 2)

INSTALLATION INSTRUC
TIO
NS
©2013 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
Poison Spyder Customs • TJ BFH™ II REAR BUMPER Page 2
mallet to lightly tap the bumper to make fine
adjustments. Tighten all mounting bolts.
6. Remove the bumper for painting or powder
coat.
7. If painting yourself, careful preparation
will make a big difference in the quality
and longevity of your paint job, even
using “rattle can” aerosol paints. Begin by
thoroughly cleaning the bumper with solvent
or de-greaser, then make sure all residue is
removed. Even if you use cheap paint, try to
use a good quality primer. “Etching” primers
are best to use on bare, unpainted metal.
Allow it to properly dry before painting, and
between paint coats.
8. Re-install the finished bumper by
repeating the installation procedures, taking
care not to damage the paint or powder coat
finish during installation.
9. Torque the 3/8-16 Gr8 Hex Head Cap
Screws to 45 ft.-lbs. Torque the M10 OE
fasteners to 40.5 ft.-lbs.
Congratulations, you have completed installation
of your BFH™ II Rear Bumper!