Poison Spyder TJ REAR BUMPER BRACE KIT - Manual (Page 2)

INSTALLATION INSTRUC
TIO
NS
©2013 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
Poison Spyder Customs • TJ REAR BUMPER BRACE KIT Page 2
5. Continue with the installation instructions
that came with your bumper. If the Braces
and Nut Plates were not painted prior to pre-
installation, they will need to be removed for
paint or powder coat before final installation.
6. If painting yourself, careful preparation
will make a big difference in the quality
and longevity of your paint job, even
using “rattle can” aerosol paints. Begin by
thoroughly cleaning the bumper with solvent
or de-greaser, then make sure all residue is
removed. Even if you use cheap paint, try to
use a good quality primer. “Etching” primers
are best to use on bare, unpainted metal.
Allow it to properly dry before painting, and
between paint coats.
7. After final installation of the bumper and
Bumper Braces, torque the 7/16-14 Gr8 Hex
Head Cap Screws to 50 ft.-lbs.
Congratulations, you have completed installation
of your TJ Rear Bumper Brace Kit!