Installation instruc tio ns – Poison Spyder REAR STINGER TIRE CARRIER User Manual

Page 3

INSTALLATION INSTRUC

TIO

Poison Spyder Customs • REAR STINGER TIRE CARRIER INSTALL

Page 3

slightly adjust the Upper Corner Mounts to

allow the bushings to swing easily into the

tabs. Test for proper fitment with the supplied

hitch pins and cotter pins. Once everything

is satisfactorily aligned, tighten the hardware

for the Upper Corner Mounts. Remove the

hitch pins and fold the Rear Stinger back

down.

11. Roll your spare tire onto the Rear Stinger

and lay it down with the outside of the wheel

facing down. Push the tire against the tire

stop on the Rear Stinger.

12. Place the 3-way Spare Tire Strap over the

spare tire, with the two lower ends (with

metal mounting tabs) draped over each side

of the tire, and the upper end (with the ratchet

mechanism) draped over the end of the tire

that is farthest from the Jeep.

13. Use the supplied 3/8” stainless steel button

head cap screws, flat washers and lock

nuts to secure each of the metal mounting

tabs of the 3-Way Spare Tire Strap to the

corresponding tabs on each side of the Rear

Stinger. Do not fully tighten this hardware

yet.

14. Pass the upper strap of the 3-Way Spare

Tire Strap through the small loop at the upper

end of the Rear Stinger, then back through

the buckle.

15. Adjust the three straps until, when tight, the

center ring is located near the center of the

tire. Once the strap is adjusted correctly, and

tightened, finish by tightening the hardware

that attaches the two lower straps to the tabs

on the Rear Stinger.

16. Test operation by folding the Rear Stinger,

with tire mounted, upward and installing the

hitch pins into each Upper Corner Mount.

Insert the hairpin cotter pins into the holes in

each hitch pin to keep them in place while in

use.

Congratulations, you have completed the

installation of your Poison Spyder Rear Stinger

Tire Carrier!