Installation instruc tio ns – Poison Spyder YJ CAGE LOWER A-PILLAR KIT User Manual

Page 2

INSTALLATION INSTRUC

TIO

Poison Spyder Customs • YJ CAGE LOWER A-PILLAR KIT INSTALL

Page 2

adjustment. Leave the bolts only snug

enough to hold the A-Pillars in place but

loose enough to allow them to slide up and

down within the slots.

7. Position the Foot Plates beneath each

A-Pillar. Make sure the plates are positioned

so that the A-Pillar lands as close to the

center as possible, but so the bolt holes

that must be drilled through the floor are

correctly located away from any obstructions

underneath the floor. Tack-weld the A-Pillars

to the Foot Plates.

8. Drill the four bolt holes into the Jeep’s

floorboards, using the holes in each of the

Foot Plates as your drill guide. Bolt the Foot

Plates into place (hardware not included in

Kit).

9. Continue with the rest of your cage

fabrication. Attach the tubular upper A-pillars

of your cage to the top surface of the Poison

Spyder Lower A-Pillar. Only tack weld this

joint during initial fabrication. Wait until the

entire cage is complete, to remove the cage

and fully weld all of the seams that were only

tack-welded during initial assembly.

Congratulations, you have completed the

installation of your Poison Spyder Lower A-Pillar

Kit!