Fast & Fluid II Series Blendorama - Manual (Page 7)

p6
© Fast & Fluid Management, Blendorama series II
Safety instructions
A - General safety instructions
Attention! Before installing the equipment, please read this instruction
manual carefully. This will increase your personal safety and prevent
unnecessary damage to the machine.
The manufacturer accepts no liability if the instructions below are not followed:
1. If a machine has been damaged (during transport, for example), do not attempt to set it in operation.
When in doubt, first contact either your supplier or the F&FM service department.
2. The equipment should be positioned and connected up in strict accordance with the installation instructions.
3. All local safety regulations and ordinances should be observed.
4. The machine may be connected only to a 230/240V/50/60Hz or 110V/50/60HZ earthed wall socket
installed in accordance with the regulations.
5. Users should ensure that the machine is kept in good condition. Defective components should be replaced.
6. In order to prevent physical injury, the doors should be closed and the paneling fitted during normal use.
7. All service activities (other than routine maintenance and adjustments) may only be carried out by
qualified technicians. Ensure that the mains lead is always kept unplugged while repairs are being carried
out.
B - Specific warnings in this manual
Attention! MOVING PARTS CAN CAUSE INJURY. Always turn off power at
the wall socket before accessing moving parts.