Fast & Fluid II Series Blendorama - Manual (Page 23)

p22
© Fast & Fluid Management, Blendorama series II
> >
(7) Once in position, press
the metalcal firmly onto the
gauge, ensuring it adheres
to the gauge along its full
length with no creases or
bubbles (use a clean cloth to
apply if necessary). (8) Using a sharp knife or
blade cut any excess
metalcal off the end of the
gauge that may overlap the
red plastic handle. (9) Refit the gauge to the
plunger.
B - Metalcal replacement (Models 22/23 XD/XE)
Before replacing the metalcals, calibrate the plungers as per the calibration instructions. Also make sure that
the replacement metalcal is the correct one - check the part numbers.
> >
(1) Remove both black and
red gauges. (2) Peel the metalcals off
both the red and black
gauges, and remove all
traces of adhesive (use a
solvent if necessary). Wipe
dry. (3) Replace both gauges and
set to the zero (fully down)
position. The locking pin at
the rear of the pump should
be engaged in the first of the
small holes.