Fast & Fluid II Series Blendorama - Manual (Page 38)

p37
© Fast & Fluid Management, Blendorama series II
Step 2 - Inner pump calibration
>
(1) Calibrate the inner pump by lowering
red pump handle fully, then refitting the
inner (red) gauge and setting it to zero.
Undo the calibration grubscrew in the red
pump handle until the handle has
movement. (2) Carefully wind the grubscrew
down until no free movement is felt
between the red pump handle and the
red gauge knob, being careful not to
over-adjust. When correctly adjusted
there should be a slight binding felt on
the red gauge locking pin (as the
locking pin shaft enters the hole in the
gauge).