Fast & Fluid II Series Blendorama User Manual

Page 24

Text mode
Original mode

p23

(4) Mark a line on the black
gauge, level with the top of
the red handle. Use a fine
felt tip pen or pencil (or
scratch with a sharp object).

(5) Remove the gauge from
the pump and peel off the
adhesive backing.

(6) Carefully place the “0”
line (the line below the
numeral) of the metalcal on
the marked line of the gauge.

(7) Once in position, press
the metalcal firmly onto the
gauge, ensuring it adheres
to the gauge along its full
length with no creases or
bubbles (use a clean cloth to
apply if necessary).

(8) Using a sharp knife or
blade cut any excess
metalcal off the end of the
gauge that may overlap the
black plastic handle.

(9) Refit the gauge to the
plunger. Repeat steps (4)
through (9) for the inner
(red) gauge metalcal.