Fast & Fluid II Series Blendorama - Manual (Page 19)

p18
© Fast & Fluid Management, Blendorama series II
>
Clean the nozzle using warm
soapy water Refit the nozzle and dispense a
small amount of colorant
If the dispenser is not used on a regular daily basis, the following procedure
should be carried out.
> >
Check the level of colorant
and top up if required Ensure that power is
connected to the dispenser
and turned on so that
automatic stirring occurs Open and close each pump
valve 5 times
>
Purge the pumps (see chapter
IV, step 2 & 3) however only
operate the pump 5 times Check the valve levers and nozzle
wiper arms for possible damage.