Fast & Fluid II Series Blendorama - Manual (Page 13)

p12
© Fast & Fluid Management, Blendorama series II
> >
Push the red pump handle
down fully to dispense
colorant into the cup Release the valve lever Repeat this process until the
colorant emerges as an
unbroken stream
Step 4 - Check the effectiveness of the purge
> >
Repeat this process 10
times. If the drop of
colorant at the nozzle grows
appreciably with each
opening of the valve lever
and/or it drops from the
nozzle into the cup, then air
is still in the system and
steps 2 & 3 should be
repeated
Open the valve lever
without operating the
pump. A small drop of
colorant will appear at the
nozzle Release the valve lever
slowly and the drop will
withdraw into the nozzle Repeat this process for all
canisters.
Attention! For dispensers fitted with electronic timers, it is important that
the machine be switch on at all times unless topping up canisters.
Attention! For manual agitation type dispensers, it is good practice to
agitate the colorant twice daily for four (4) minutes.