Brother HL-3400CN Series - Manual (Page 92)

CHAPTER 4 CONTROL PANEL
4–21
Display Message Parameters Settings
DTR(ER) =ON
(Effective when
Xon/Xoff=ON)
Data terminal ready
(ER) ON: Makes DTR (ER) low when
the buffer is full.
OFF: Does not make DTR (ER)
low when the buffer is full.
DTR(ER) goes low only
when the printer is off-line.
Robust Xon =OFF
(Effective when
Xon/Xoff=ON)
Robust Xon ON: Sends Xon while waiting.
OFF: Sends Xon once, when the
printer status changes from
off-line to on-line.
■ Extended I/O Interface
If you have installed a commercial modular input/output (MIO) card in
the printer, you can select the extended I/O interface in this mode. If the
installed MIO card requires any optional interface settings, they appear
under this menu. To set them up, referring to the manual for the MIO
card.
✒ Note
This setting appears only when an MIO card has been installed. For
installation of the MIO card, see the Network manual.
The network card may be pre-installed on some HL-3400CN series
models.