Brother HL-3400CN Series - Manual (Page 51)

CHAPTER 2 SETTING UP THE PRINTER
2–21
Printing the Test Patterns or Lists
You can check print quality and print a list of available fonts before you
actually start working with the printer. To do so, follow these steps:
1. Make sure that you have already installed the toner cartridges,
the OPC Belt Cartridge, the Oil Bottle and the Fuser Cleaner
and have loaded paper into the cassette. Make sure that you
have removed the protective parts on the Waste Toner Pack.
2 Turn on the printer. Wait until the display shows the following
message:
LJ READY 001P T1
AUTO
K C M Y
3. Press the Sel button to take the printer off-line.
The On Line LED goes off.
4. Hold down the Shift button and press the Test button. Release
both buttons.
5. Press the ▲ or ▼ button to scroll through the display until the
desired message appears.
Choose from one of the following selections:
To Print LCD Message
the Demonstration Page DEMO PAGE
the Test Pattern TEST PRINT
the list of printer settings PRINT CONFIG
the list of internal or resident fonts PRINT FONTS I
the list of optional card fonts PRINT FONTS C
the list of permanent download fonts PRINT FONTS P
To exit from the test mode, select “ exit ”.
✒ Notes
The messages “PRINT FONTS C” or “PRINT FONTS P” appear only
when an optional font card is installed in the font slot or when permanent
download fonts are stored in printer memory.
•
If the optional font card is installed, you can print a list of optional
fonts. Since the list shows the ID numbers specific to each optional
font, it helps you select them with the
Font button. For more
information, see “FONT Button” in Chapter 4 .
•
If user-defined characters are already downloaded into the printer
memory as permanent download fonts, you can print a list of them.
For more information, see
“FONT Button” in Chapter 4 .