Brother HL-3400CN Series - Manual (Page 89)

USER’S GUIDE
4–18
Operation Example: Selecting the Parallel Interface
To manually select the parallel interface:
1. Press the Sel button to take the printer off-line.
2. Press the Mode button and then press the Set Button.
When you enter the interface mode, the display first shows the
current interface with the asterisk.
3. Press the ▲ or ▼ button until the interface you want appears on
the display.
Display Message Interface Mode
I/F=PARALLEL Parallel interface
I/F=RS-232C Serial interface
I/F=EXTEND I/O Extended I/O interface
I/F=AUTO Auto interface selection
✒ Note
•
The Extended I/O interface is available only when a commercial MIO
compatible sharing/network card has been installed.
•
Some models are supplied with the network card pre-installed.
4. Press the Set button to save your selection.
An asterisk appears at the end of the display for a short time.
Then the printer automatically exits from the setting menu to
the interface menu.
5. Press the ▲ or ▼ button until the exit menu appears on the
display.
6. Press the Set button.
The printer then automatically returns to the off-line ready
state.