List of factory settings – Brother HL-3400CN Series User Manual
Page 146
CHAPTER 4 CONTROL PANEL
4–75
4. Press the
Set
button to make the displayed selection effective.
The printer is reset according to the selected reset mode.
Selected Mode
LCD message
RESET PRINTER
08 RESET TO
↔
USER SETTINGS
RESET SETTING 1-2
08 RESET TO
↔
SETTING # 1*
FACTORY SETTINGS
09 RESET TO
↔
FACTORY
SETTINGS
1* - # indicates the selected number of saved settings
The printer automatically exits from the reset mode to the on-
line state.
5. When you enter the RESET PARTS LIFE mode:
LCD Message
Parts replaced
FC ROLLER
Fuser Cleaner
OPC BELT
(OPC) Belt Cartridge
FUSER UNIT
Fixing Unit
240K KIT
Drum Cleaner, Paper Discharge,
Transfer Roller
The reset item is selected according to the Maintenance message that
shows the currently recommended part to replace. Press
Set
to reset
for more detailed information.
List of Factory Settings
The following table shows the factory settings made before shipment.
✒ Notes
•
The settings are subject to the emulation mode. Effective modes are
indicated in parentheses in the following table.
•
The following settings cannot be restored to the factory settings with
the
Reset
button in the “FACTORY SETTINGS” mode:
INTERFACE MODE, HRC SETTING, PAGE PROTECTION,
SCALABLE FONT, LOCK PANEL, PAGE COUNTER and local
LANGUAGE for display messages.
•
The COPY setting is always restored to the factory setting when the
printer is turned off and on again.
•
The user settings are overwritten after resetting to User Settings 1 or
2.