Brother HL-3400CN Series - Manual (Page 207)

USER’S GUIDE
5-50
Font Card, Flash Memory/HDD Card
Installing a Font Card, Flash Memory Card and HDD Card
This printer has two slots for an optional font cartridge and one slot for an
optional font card, flash memory card or HDD card. (Type III HDD cards
will only fit into card slot 2.)
If you have installed optional font card(s), you can use the fonts stored in
them as well as the resident fonts. For optional font cards, consult the
dealer where you purchased the printer.
If you have installed an optional flash memory card or HDD card, you
can save macros and fonts on it. For flash memory card and HDD card
operations and information, see
“DEVICE OPERATION” in Chapter 4 .
✒ Notes
• Do not install or remove cards with the power on, or you may lose all
data and may seriously damage the card.
•
For more information about these cards, consult the dealer where you
purchased the printer.
• For the latest information: http://www.brother.com
Follow these steps to install or remove a card:
1. Make sure the printer is turned off.
If the printer is turned on, be sure to press the
Sel button to
take the printer off-line. If data remains in the printer memory,
the
Data LED stays on. Press the Form Feed button to print
out the remaining data. When then the Data LED is off, turn
off the printer.
2. Insert an HDD card into slot 2 with the label facing to the right.
The HDDcard will only fit in slot 2.
3. Insert a flash memory or font card into either slot 1 or slot 2 with
the label facing to the right. Make sure they are inserted correctly.
To remove a card, pull it out of the slot with the printer turned off.