Toshiba Magnia Z300 - Manual (Page 88)

4.3.1.4 Access point
The following is the setting procedure for the access point.
Step 1 Setting the 802.1X function at the access point
Make settings for the 802.1X function.
The following procedure is to enable the 802.1X function. The other settings of the [Basic setting] and [Access
restriction] tabs are omitted.
1. Start the access point setting utility.
2. Select the [WEP] tab.
3. 802.1X group
Select [Used] in the [802.1X] component box.
Place a check mark in the [Distribute WEP key] check box.
Do not place a check mark in the [Reauthenticate before WEP key distribution] check box.
Set 600 in the [WEP key change interval] edit box.
Select the [Key length] radio button of [13 byte].
4. RADIUS group
Place a check mark in the [RADIUS Server 1] check box.
Set a value in the [IP Address] edit box. Enter the IP address of the RADIUS server. In this
example, set 127.0.0.1.
Set a value in the [Shared Secret] edit box. Shared secret is a password for communication
between the access point and the RADIUS server. In this example, set "my shared secret."
Set a value in the [Time-out] edit box. In this example, set 20.
80