Toshiba Magnia Z300 - Manual (Page 50)

3.2.2 Using the utility
When the Access Point Configuration Utility is started, the main screen is displayed showing the following
three pages:
[Basic Setting]
[Access Restriction]
[Hardware Resource](displayed only when Windows NT is used)
Immediately after the utility starts, the current settings of the MAGNIA Software Access Point are displayed
on the respective pages.
Buttons common to all pages
Item Explanation
[Connect to] button Displays the connection destination setting screen. Use this
button to be connected to the remote Software Access Point.
[3.3 Access Point Configuration Utility]
[Close] button Quits the Access Point Configuration Utility.
[Refresh] button Refreshes the settings.
[Apply] button Applies the changes made on the settings.
42