Toshiba Magnia Z300 - Manual (Page 104)

Access Point Configuration Utility
Problem Correction
When the Access Point Configuration Utility starts, the
message "Loading of the library required for
communication with access point failed" is displayed. · The utility may be incorrectly installed. Reinstall the
utility.
When the Access Point Configuration Utility starts, the
message "The access point is disabled. The changes are
applied when the access point is enabled next" is displayed. · Check whether the driver is normally operating on the
server (access point).
When the network is connected from a remote PC with the
Access Point Configuration Utility, the message
"Communication with the access point failed" is displayed. · Check whether the specified computer name is correct.
· By using the ping command, check whether the network is
disconnected.
· The SNMP Extension Agent needs to be operating on the
server (access point). Check whether the SNMP Extension
Agent is correctly installed.
· Check whether the driver is normally operating on the
server (access point).
When the network is connected from a remote PC with the
Access Point Configuration Utility, the message
"Acquisition of property values failed" is displayed. · Check whether the specified community name is correct.
· The access point may be busy. Wait a while and re-execute
the utility.
The Access Point Configuration Utility displays the
message "Reading of settings failed." · The access point may be busy. Wait a while and re-execute
the utility.
· By using the ping command, check whether the network is
disconnected.
When setting contents are applied in the Access Point
Configuration Utility, the message "Writing of settings
failed." · The access point may be busy. Wait a while and re-execute
the utility.
· By using the ping command, check whether the network is
disconnected.
· When the network is used from the remote PC, it must be
connected with a community name with writing authority.
Check whether the specified community name is correct,
and the authority is correctly set up.
· Please check if you try to change the access point settings
from a wireless-LAN station, which is connected to the
access point. The above usage is out of specification.
96