Pioneer KRP-600A - Manual (Page 24)

Watching TV 06
24
En
Chapter 6
Watching TV
Important
• Before watching broadcast channels, the built-in TV tuner must
be set up. See Setting up TV channels on page 33 for how to do
this.
Turning the power on/off
Note
• When the Media Receiver is plugged into a power outlet, it is
placed into standby mode; the STANDBY indicator on its front
panel should flash red. The Media Receiver stays in standby
mode unless it is unplugged from the power outlet.
To turn on the system, press the Power On ( a) button on the
display.
• The Power ON indicators on the display and Media Receiver
light up blue.
To turn off the system, press a on the remote control unit or
STANDBY/ON on the Media Receiver.
• The display and Media Receiver are placed into standby mode;
their respective STANDBY indicators light up red.
• You can then turn on the system again by pressing a or 0 to 9
on the remote control unit or STANDBY/ON on the Media
Receiver.
• If you press 0 on the remote control unit, images from “INPUT 1”
will be displayed.
• If you press 1 to 9, TV images will be displayed.
You can also press the Power On ( a) button on the display to turn
off the system. However, you cannot then turn on the system again
by pressing the buttons on the remote control unit and Media
Receiver.
Note
• When the Power On ( a) button on the display is off, you cannot
turn the power on by pressing a or 0 to 9 on the remote control
unit or STANDBY/ON on the Media Receiver.
• While the system is placed into standby mode, pressing remote
control’s a causes the flat screen TV to turn on.
• When the system is placed into standby mode, the main power
flow is cut and the system is no longer fully operational. A minute
flow of power feeds the system to maintain operational readiness.
• If you are not going to use the flat screen TV for a long period of
time, be sure to remove the power cord from the power outlet.
Power On ( a ) button
Power ON indicator
STANDBY indicator
Display
STANDBY/ON INPUT
ON STANDBY TIMER
VOLUME CHANNEL
PHONES
USB HDMI
INPUT 5 VIDEO ANALOG RGB L AUDIO R
PC
KRP-M01
COMMON INTERFACE 2 SATELLITE
COMMON INTERFACE 1 TERRESTRIAL  EJECT
STANDBY/ON button
Power ON indicator
STANDBY indicator
Media Receiver (front)
KRP-600A_500A.book Page 24 Monday, September 8, 2008 10:31 AM