Pioneer KRP-600A - Manual (Page 19)

Preparation 05
19
En
E
n
glish
Important
The colour sensor may not operate properly:
• if attached by methods other than specified above
• if anything blocks light falling on the sensor window
• if light falls on only part of the sensor window
• if the light falling on the sensor window and the panel screen
differs
Note
• If the colour sensor attached to the rear panel does not operate
properly, attach it to the front panel.
• The colour sensor may become hot due to a heat emitted from
the panel. When using it in a high-temperature environment,
attach the colour sensor to the bottom of the front panel.
• Do not use the screws supplied for the speakers.
Basic connections
Connecting the antenna
To enjoy a clearer picture, use an outdoor antenna. The following is
a brief explanation of the types of connections that are used for a
coaxial cable.
Caution
• When the “Aerial Power” setting is on, directly connect the
aerial to the ANT input terminal at the rear of the Media
Receiver. Connecting any device between the aerial and Media
Receiver may cause damage to the device.
• Connect a 75-ohm coaxial cable (commercially available) to the
ANT terminal.
• If “Aerial Power” setting is enabled, use an indoor antenna with
signal amplifier, 5 V 30 mA.
Antenna cable (commercially available)
If your outdoor antenna uses a 75-ohm coaxial cable with a
standard DIN45325 plug (IEC169-2), plug it into the antenna
terminal at the rear of the Media Receiver.
Note
• If the antenna is not connected correctly, the quality of reception
may be impaired. If images are not displaying correctly, check
whether the antenna connection is correct or not.
Connecting the satellite antenna
There are three different connection methods available as shown
below. Select the appropriate menu according to the switch you use.
See
Setting up satellite TV channels manually on page 33. If no
details on how the antenna is connected (in a building, for example),
select “SMATV” from “Scan Type” on the “Satellite Setup” menu.
SAT
ANT
LAN (10 / 100)
INPUT 3
INPUT 1
OPTIC
INP
Standard DIN45325 plug (IEC169-2)
75-ohm coaxial cable (round cable)
(commercially available)
Media Receiver (rear)
SAT
ANT
LA
INPUT 3
INPUT 1
Direct connection to the Media Receiver
Satellite antenna
SAT (Satellite)
input terminal
SAT
ANT
LA
INPUT 3
INPUT 1
Using Tone Burst
SAT (Satellite)
input terminal
Satellite antenna
SW (Tone Burst)
KRP-600A_500A.book Page 19 Monday, September 8, 2008 10:31 AM