Pioneer KRP-600A - Manual (Page 21)

Preparation 05
21
En
E
n
glish
Note
• Avoid pinching or creating pressure points when routing or
bundling cables.
• The longer a clamp is in place, the better chance of
deterioration. An older clamp is more easily damaged while
being removed and may not be reusable.
• Use the cable clamps as necessary.
• Be careful not to subject any connecting cables to strain.
Attaching the ferrite core
Attach the accessory ferrite core to the end of the display and the
Media Receiver’s power cords as shown in the accompanying
illustration. Use the provided cable tie to prevent the ferrite core
from slipping on the cable.
If you do not do this, the flat screen TV will not conform to
mandatory CE standards.
Caution
• Do not use the SYSTEM cable to connect other equipment to the
flat screen TV.
Note
• The SYSTEM cable comes with the same terminals on both
ends.
• Do not connect an HDMI cable to the SYSTEM CABLE terminal.
• When removing the SYSTEM cable, push and hold the latch on
the connector to release.
1
2
3
4
Ferrite core
To power outlet
AC power cord
As close as possible
Cable tie
To display and
Media Receiver
AC IN
SERVICE ONLY
SAT
ANT
AUDIO OUT SUB WOOFER OUT INPUT 2
L
L R AUDIO
P R
COMPONENT VIDEO
P B Y
R
SYSTEM
CABLE
CONTROL
LAN (10 / 100)
INPUT 3
INPUT 1
INPUT 4
HDMI
INPUT 3
HDMI
INPUT 1
DIGITAL OUT
OPTICAL
HDMI OUT
INPUT 2
Connecting the SYSTEM cable to the Media Receiver
Connecting the SYSTEM cable to the display
Media Receiver (rear)
SYSTEM cable
Display (rear)
Connecting the SYSTEM cable
KRP-600A_500A.book Page 21 Monday, September 8, 2008 10:31 AM