Xerox WorkCentre PE120-120i-4396 - Manual (Page 92)

Page 6-26 Xerox WorkCentre PE120i System Administration Guide
Ne
twor
k Ins
ta
lla
tio
n
Us
in
g In
ter
n e t Se
rv
ic
e s HTTP
Use these instructions to setup HTTP using CentreWare Internet Services.
NOTE: The HTTP settings for the device will have been setup when completing the
Enabling CentreWare Internet Services section.
To complete the installation of the device, perform these steps:
¾ Enable CentreWare Internet Services (see “Enabling Internet Services” on page 6-5).
¾ At the CentreWare Internet Services Home Page for the WorkCentre PE120i, select the
[Properties] tab.
¾ Select the plus symbol [+] to the left of the Connectivity folder in the Properties frame,
and then select the [+] symbol to the left of the Protocol folder.
¾ Check the HTTP Configuration details are correct. If necessary.
Enter the [Keep Alive Timeout] in seconds from 5 to 99.
Enter the [Maximum Connections] from 5 to 16.
¾ Click the [Apply] button to implement any changes.
NOTE: Click the [Undo] button to cancel any changes made and return to the
previous values.
¾ Select the [Status] tab and then select [Reset Network Controller] to enable the
selections to take effect.
¾ Continue with Test Print.
1
3
4
5
6
7
8