Xerox WorkCentre PE120-120i-4396 - Manual (Page 60)

Page 5-4 Xerox WorkCentre PE120i System Administration Guide
Ap
pl
eT
al
k
NOTE: The WorkCentre PE120i will attach itself to the default zone of the local
segment where it is connected.
¾ Install the Printer Driver (see “Printer Driver Installation (Mac OS 8x,9x only)” on page 5-5).
3
¾ Press or until Configure
Network is displayed and press
[Enter].
8. Network Setup
[Config Network]
4
¾ Press or until Configure
Network is displayed and press
[Enter].
¾ Press or until Ethertalk
is displayed and press [Enter].
Config Network
[Ethertalk]
5 ¾ To enable or disable Ethertalk,
press or until the
desired setting, [On] or [Off] is
displayed and press [Enter]. Ethertalk
[On]
6