Xerox WorkCentre PE120-120i-4396 - Manual (Page 77)

Xerox WorkCentre PE120i System Administration Guide Page 6-11
Ne
twor
k Ins
tal
la
tio
n
Us
in
g In
ter
net
Se
rv
ic
es NetWare
Use these instructions to install WorkCentre PE120i on a NetWare network using CentreWare
Internet Services.
Installation Procedure
There are three stages required to install the WorkCentre PE120i on a NetWare network using
CentreWare Internet Services:
¾ PCONSOLE or NWADMIN Setup
This procedure is used to setup the network using NetWare’s PCONSOLE or
NWADMIN utility.
¾ Configure the WorkCentre PE120i
This procedure explains how to use CentreWare Internet Services to
configure the WorkCentre PE120i.
¾ Test Print
A print job should be submitted to ensure the device has been installed and
configured correctly.
PCONSOLE or NWADMIN Setup
If running NLSP, be sure that RIP/SAP compatibility is configured on the same segment as the
WorkCentre PE120i.
Using the PCONSOLE or NWADMIN utility, perform the following steps:
¾ Login to File Server as Supervisor or equivalent.
¾ Create the Print Queue.
¾ Create Print Server Name and Password.
¾ Define the printer as Defined Elsewhere or Remote/Other Unknown.
¾ Verify the Frame Type.
1
2
3
4
5