Xerox WorkCentre PE120-120i-4396 - Manual (Page 39)

Xerox WorkCentre PE120i System Administration Guide Page 3-5
Ne
tW
a re Using NetWare Utilities
Installation Procedure
There are three stages required to install the WorkCentre PE120i on a NetWare network using
NetWare utilities:
¾ Network Communication Setup
This procedure will enable the WorkCentre PE120i to communicate on the
NetWare network.
¾ NetWare Setup
This procedure is used to setup the network using NetWare utilities, for
example NWADMIN.
¾ Test Print
A print job should be submitted to ensure the WorkCentre PE120i has been
installed and configured correctly.
If running NLSP, ensure that RIP/SAP compatibility is configured on the same segment as the
WorkCentre PE120i.
Network Communication Setup
At the WorkCentre PE120i, perform these steps:
HINT: Xerox CentreWare Internet Services can also be used to configure the
WorkCentre PE120i, refer to the Internet Services chapter for instructions.
¾ Ensure that the Basic TCP/IP settings have been configured (see “Network
Communication Setup” on page 2-5). 1
2
¾ Press [Menu] until you see
Network Setup on the top line of
the display.
8. Network Setup
[Reset Network]