Xerox WorkCentre PE120-120i-4396 - Manual (Page 78)

Page 6-12 Xerox WorkCentre PE120i System Administration Guide
Ne
twor
k Ins
ta
lla
tio
n
Us
in
g In
ter
n e t Se
rv
ic
e s ¾ Obtain and record the following information from the setup just completed. This
information is needed to configure the device with CentreWare Internet Services:
File Server Name
Print Server Name
Print Server Password
Frame Type
¾ Continue with Configure the WorkCentre PE120i.
Configure the WorkCentre PE120i
To complete the installation of the WorkCentre PE120i, perform these steps:
¾ Enable CentreWare Internet Services (see “Enabling Internet Services” on page 6-5).
¾ At the CentreWare Internet Services Home Page for the WorkCentre PE120i, select the
[Properties] tab.
¾ Select the plus symbol [+] to the left of the Connectivity folder in the Properties frame,
and then select the [+] symbol to the left of the Protocols folder.
¾ In the Properties frame, within the Physical Connections folder, select [NetWare].
¾ Make the following selections and settings in the General section of the Protocols frame:
Select the checkbox to enable NetWare.
Choose the [Frame Type].
Set the [Queue Poll Interval].
This value determines how often the WorkCentre PE120i polls the NetWare file server to
check if there is a file at the server to be printed or faxed. Enter a value from 10 to 240
seconds.
Enter the [Print Server] name. Use a meaningful name, such as the location of the
device.
NOTE: The Printer Server Name must match that entered using PConsole or the
NW Admin utility.
6
7
1
2
3
4
5