Konica Minolta Bizhub 215 - Manual (Page 30)

bizhub 215 3-4
3.2 Loading the original 3
3.2 Loading the original
The original loading methods are classified into two types: loading the original into the ADF and loading the
original on the Original Glass. Load the original in the appropriate method to fit the original type.
3.2.1 Loading the original into the ADF
1
Press the Fax key.
The machine switches to the fax mode.
2
Load the original into the ADF, turning up the side to be scanned.
% Up to 70 sheets can be loaded for A3-size plain paper.
% Do not load more than 70 sheets into the ADF at a time, and do not load the sheets up to the point
where the top of the stack is higher than the , mark. Doing so would cause the original to jam or
become spoiled, or cause the machine to fail.
% If the original is 17 inches (432 mm) or more in length, only one sheet can be loaded.
% When scanning a 2-sided original, load it into the ADF, turning
the first page up.
3
Adjust the Lateral Guide to the original size.
% A custom-size original can be scanned up to the sizes shown below.
If the memory does not contain any received data, polling RX data, and other data, approximately 1,024
sheets (A4 standard original) can be scanned into the memory at one time.
Minimum size
39-1/2 inch
(1000 mm)
11-11/16 inch (297 mm)
Maximum size
Paper feed
direction
8-1/2 inch (210 mm)
(Sizes less than 8-1/2 inch (210 mm)
are scanned as 8-1/2 inch (210 mm).)
Paper feed
direction
5-1/2 inch
(139.7 mm)