Konica Minolta BIZHUB C360 - Manual (Page 6)

for Customer Engineer
Issued by BT-CSO Ver 1.01 6
Necessary information to perform License operation
You need to get necessary information for each operation and send it to MFP and LMS to
execute the license operations.
Following chart shows necessary information for each operation.
Activation Deactivation Repair Initialization To LMS From LMS
Serial Number X X X X X
Token Number X X X(*1) X(*2) X
Request Code X X X X
License Code X X(*1) X(*2) X
Function Code X X X(*1) X(*2) X
Deactivation code X X
Deactivation Complete Code X X
Repair Request Code (Repair
Demand Code)
X X
Repair Code
(Repair Permission Code)
X X
Initialization Code X X(*3)
*1 If you exchange NVRAM when performing Repair, you need this information.
*2 Require when re-activate the functions after the initialization.
*3 Necessary to contact the support to acquire the code.
Explanation of those Numbers used on those operations/ Codes are as follows.
— Serial Number
Serial Number for MFP body.
— Token Number
Token Number is printed on the Token Kit, or will be informed when purchasing the
license. You need this number to enable License Activation Base Functions.
— Request Code
This is ID Number to recognize the individual MFP. Serial Number information is
also included in the Request Code.
— License Management Server (LMS)
The Server performs license management. When you activate/ deactivate or make
other operations for License Activation Base Functions, you need to access the
License Management Server (Web site).