Konica Minolta BIZHUB C360 - Manual (Page 13)

for Customer Engineer
Issued by BT-CSO Ver 1.01 13
Activation Procedure
The following is the step by step procedure to activate License Activation Base Functions.
1. Gather information from MFP/ Kit
1-1. Find [Token Number] from License Kit.
1-2. Get [Request Code] and [Serial Number] from MFP.
2. Access to LMS
2-1. Access to LMS and get [License Code] and [Function Code].
3. MFP Activation
3-1. Input [License Code] and [Function Code], and activate the function.
When using each code, please pay attention “U” and “V”, “0(number)” and “O(alphabet)”.
“0 (Number)” is not used in [Request Code] and [License Code].
Here are necessary information (operation) and acquisition procedure in the above steps.
Information (operation) Acquisition Procedure Note
Token Number Token Certificate (License Kit) 20 digits alphanumeric
Request Code a) MFP panel
- Administrator Mode
- Service Mode
b) PSWC (Administrator Mode)
30 digits alphanumeric
Serial Number Get Serial number when taking
Request Code.
Serial Number Label
13 digits alphanumeric
EG.) A00H020012345
License Code LMS (Web browser) 30 digits alphanumeric
Function Code LMS (Web browser)
Activation
(Input License Code)
a) MFP panel
- Administrator Mode
- Service Mode
b) PSWC (Administrator Mode)
*If it is possible to access MFP and LMS from the PC, you can perform the procedure (from
getting Token Number to performing activation) from “License Install Utility”.
(About the detailed procedure, please refer to “License Install Utility” of Users Guide.)