beautypg.com

Konica Minolta BIZHUB C360 User Manual

Page 51

background image

for Customer Engineer

Issued by BT-CSO

Ver 1.01

51

Repair

After replacement of the parts, the message “License Management Error occurred” may be

displayed on the control panel. When the message appears, it is necessary to perform

repair operation.

¾ The repair operation can be done with accessing LMS. When those parts as listed

below are replaced, the message “License Management Error” may be displayed.

¾ When replacing those parts below, please replace it with new parts. When the

parts are replaced with used parts, the message condition can not be solved by

performing the repair operation.

— NVRAM

— Service

EEPROM

Board

¾ If License Activation Base function was already activated

z While the error message is indicated on the control panel, the License Activation

Base Function will not be disabled.

z When the error message is indicated after replacement of the NVRAM, License

Activation is required after the completion of the repair operation to use the

function again.

¾

If License Activation Base function was not activated

z Even the function was not activated, the message may be indicated if those

parts mentioned before is replaced. MFP can be used without the repair

operation, but to solve it, the repair operation is required.

This manual is related to the following products: