Sioux Chief DWV Extension Hanger - Adjust 2 Hang - Manual

www.siouxchief.com
#IS-553-326 9/13 File 7065
Patent #8,356,777 B2
Supply Drainage Support
#553-326
1
4
2 3
STEP 1 - Secure mounting block to wood joist.
Nails should be installed on opposite side of
thumb lever.
Mount Two Nails, 1½" Shaft Receiver Zip Tie
STEP 4 - Pull Zip Tie to tighten around pipe. To
release Zip Tie, depress small thumb lever and
pull away from pipe.
STEP 2 - Insert shaft through bottom side of
mounting block.
Making Adjustments
Raise Pipe: Push shaft up. Each click engages
teeth by ¼".
Lower pipe: While holding shaft, depress thumb
lever to release teeth. Make sure shaft teeth fully
engage mounting block.
STEP 3 - Holding pipe, wrap Zip Tie around
pipe, threading end of Zip Tie through
rectangular opening.
For Tight Spaces - Use Receiver and Zip Tie only.
Attach Receiver to structure using one screw (not
provided). Thread Zip Tie through Receiver and
pull Zip Tie until tightly fastened around pipe.
24110 South Peculiar Drive
Peculiar, Missouri 64078
P 1 . 8 0 0 . 8 2 1 . 3 9 4 4
F 1 . 8 0 0 . 75 8 . 5950
Adjust 2 Hang™ DWV extension hanger can be used to support or suspend ½" CTS through 4" DWV. Product shall be in-
stalled according to national or local code requirements for each jurisdiction.
Teeth on shaft are at ¼" intervals allowing installer to easily set slope or fall of DWV pipe during or after hanger is installed.
Receiver end of shaft swivels 360º for full adjustability to secure pipe coming from any direction.
Thumb lever
Adjust 2 Hang ™ DWV Extension Hanger
Installation Instructions