beautypg.com

3 control1 (01h), Cs8416 – Cirrus Logic CS8416 User Manual

Page 37

background image

DS578F3

37

CS8416

1 – Higher Update Rate Phase Detector - Recovered master clock (RMCK) will have low in-band jitter, but
increased wide-band jitter. Use this setting for the best performance when the output is connected to a delta-
sigma digital-to-analog converter (DAC).

TRUNC

– Determines if the audio word length is set according to the incoming channel status data as de-

coded by the AUX[3:0] bits. The resulting word length in bits is 24 minus AUX[3:0].

Default = ‘0’

0 – Incoming data is not truncated.
1 – Incoming data is truncated according to the length specified in the channel status data.

Truncation occurs before the de-emphasis filter. TRUNC has no effect on output data if de-emphasis filter
is not used.

Reserved

– These bits may change state depending on the input audio data.

14.3 Control1 (01h)

SWCLK

- Lets OMCK determine RMCK, OSCLK, OLRCK when PLL loses lock

Default = ‘0’

0 - Disable automatic clock switching. RMCK runs at the VCO frequency (~750 kHz) on PLL Unlock.
1 - Enable automatic clock switching on PLL unlock. OMCK clock input is automatically output on RMCK on
PLL Unlock.

MUTESAO

- Mute control for the serial audio output port

Default = ‘0’

0 - SDOUT not muted.
1 – SDOUT muted (set to all zeros).

INT[1:0]

- Interrupt output pin (INT) control

Default = ‘00’

00 - Active high; high output indicates interrupt condition has occurred.
01 - Active low, low output indicates an interrupt condition has occurred.
10 - Open drain, active low. Requires an external pull-up resistor on the INT pin. Thus it is not recommended
to multiplex INT onto GPO2 in I²C Control Port Mode since an external resistor is required on GPO2 to spec-
ify the AD2 bit of the chip address.

11 – Reserved.

HOLD[1:0]

– Determine how received audio sample is affected when a receive error occurs

Default = ‘00’

00 – hold last audio sample.
01 – replace the current audio sample with all zeros (mute).
10- do not change the received audio sample.
11 - reserved

7

6

5

4

3

2

1

0

SWCLK

MUTESAO

INT1

INT0

HOLD1

HOLD0

RMCKF

CHS