Festo Контроллер двигателя SFC-ST - Manual (Page 66)

4. Parametrizing blocks
4−12
Festo P.BE−SFC−DC−PB−S7−E N en 0604NH
If the parameter is faulty, the transmission will be aborted.
The fault can be identified by means of the incorrect
parameter values which are still present in the block.
Fig. 4/6: Block for transferring a parameter list
Fault treatment
Transmission faults are shown with the Fault bit. The paraĆ
meter which caused the fault can be read with the last transĆ
ferred parameter values.
Information on faults can be found in section 4.5.