Festo Контроллер двигателя SFC-ST - Manual (Page 60)

4. Parametrizing blocks
4−6
Festo P.BE−SFC−DC−PB−S7−E N en 0604NH
4.2 Block PRM_FPC
The block transfers the parameters internally to the FPC
(Festo Parameter Channel).
Fig. 4/1: Parametrizing via the cyclic data
Fault treatment
Transmission faults are displayed with the Fault bit, the paraĆ
meter Length_RD then contains value 2.
The cause of the fault will be output at Value_RD.
Information on faults can be found in section 4.5.