Goulds Pumps 3600 - IOM - Manual (Page 61)

Maintenance
Disassemble the radial end (sleeve/ball bearing pumps)
1. Remove the two dowel pins between the upper and lower halves of the bearing housing
(134).
2. Remove the hex screws that connect the upper and lower halves of the bearing housing.
3. Tighten the two jackscrews on the horizontal parting flanges of the bearing housing in order
to separate the two halves.
4. Remove the top half of the bearing housing with the upper half of the sleeve bearing (117).
Notice that the bearing is pinned to the bearing housing.
Model 3600, API 610 8th, 9th, 10th & 11th Editions (ISO 13709) Installation, Operation, and Maintenance Manual 59