ARRI ARRIFLEX 416 - Manual (Page 68)

Displaying and Setting the Timecode User Bits
(Mode 5)
User Bits are automatically input with the timecode signal
but they may also be set manually in Mode 5.
• Press the “MODE“ button until the display shows Mode 5.
• Use the “SEL” button to select the digit you wish to change.
The selected digit will flash.
• The “SET” button changes the value of the flashing digit.
• Repeat the last two steps for all the digits that need to
be changed.
Note: User Bits are hexadecimal so only values
between 0 - 9 and A - F are available.
Camera
Operation
Setting the brightness of the button illumination
(Mode 6)
• Change from Mode 1 to Mode 4 by pressing the
“MODE” button five times.
• Press the “SEL” button three times to activate the
display for setting the button illumination.
• Select the desired brightness using the “SET” button.
0…off
3…maximum brightness