ARRI ARRIFLEX 416 - Manual (Page 46)

7.2 Exchanging the Fibre Screen
• In Standby, briefly press the “PHASE” button to position
the shutter so the mirror surface is protected from
damage as far as possible a photo .
• Before exchanging the fibre screen, switch the camera’s
main switch off and disconnect the camera from the
power supply!
• Remove the lens or the protective cap.
Do not touch the mirror surface!
• Using the special forceps (Hirschmann Clamp) from the
camera‘s toolkit, pull the fibre screen a photo out of
the holder by its tongue a photo .
• Check that both the fibre screen to be inserted and its
frame are completely clean.
• With the special forceps, push the chosen fibre screen
into the holder as far as it will go. A sprung-ball catch
fixes the fibre screen exactly in the right position.
• Check that the fibre screen is correctly locked in place.
Note: Cleaning or exchanging the field lens is
covered in Chapter 14 Maintenance, Cleaning
the Field Lens.
Camera
Body
phase button
tongue
fibre screen