ARRI ARRIFLEX 416 - Manual (Page 188)

1
12.3 Wireless Remote System
Lens Motors
Both CLM-1 and CLM-2 motors can be used with the
ARRIFLEX 416 Plus.
• CLM-1 motors should be daisy-chained in series with one
of the end motors connected to either (but not both) of
the 416 Plus LCS bus connectors a photo .
• CLM-2 motors should be connected, according to their
position on the lens, to the Zoom, Focus and Iris
connectors of the 416 Plus a photo .
• CLM-1 and CLM-2 motors may be used simultaneously
but only on different lens axes.
In the situation where a CLM-1 is assigned to Focus and a
CLM-2 is simultaneously plugged into the Focus connector,
the CLM-1 will have priority and the CLM-2 connection will
be deactivated. The same applies to the Zoom and Iris axes.
Each CLM-2 motor connection has a direction switch
a photo and a status LED a photo .
• Use the direction switch to change the direction of
rotation of the attached motor.
LCS bus connectors
status LED
direction switch
Zoom
Focus
Iris
ARRIFLEX
1
Plu
s