Ferguson RW-770 HD - Manual (Page 47)

- 47 -
TROUBLESHOOTING
Problem Solution
No sound • Connect the audio cables into the connectors securely.
• Verify the connection from the DVD audio output to the TV or receiver audio input. Make
sure the correct AUDIO input is selected on your TV or amplifier.
• Refer to your audio amplifier owners manual.
Only sound, no
picture • The scan mode of video output is incorrectly set. Press the P/I button on the remote
control to switch to correct mode.
No response • Connect the power plug into the wall outlet securely.
• Timer recording is active. Press Power or Stop to cancel time recording.
• The appliance might encounter a technical failure. Unplug the power supply and wait for
30 seconds before connecting it to the wall outlet again. If it still doesn't work, try to
resume the Multimedia Recorder to factory settings.
Remote control
does not work • The remote control is not pointing to the Multimedia Recorder. Please aim at the
Multimedia Recorder.
• Batteries are flat, replace batteries.
• The appliance might encounter a technical failure. Unload batteries, wait for 30 seconds
before place them back into the remote control.
Cannot play disc • Blank disc, replace the disc.
• Incompatible disc: please refer to the list of supported disc types at the start of this
guide.
• The disc is loaded with label side down. Make sure to load the disc with label side up.
• Wrong region code. The region code does not match the region setting of the Multimedia
Recorder.
• Parental lock is on. Unlock the parental lock. Default password is 0000 or 3308.
• Choose channel number on the TV set. Choose a correct channel number.
• The connection between the Multimedia Recorder and TV set is loose. Check the
connection.
Poor playing
quality (distorted
picture/sound) • The TV set is not adjusted to the best status.
• The disc is dirty, clean the disc.
• Interference may also make the picture distorted.
• The wrong setting for the output mode can cause a blank screen or bad quality. If you
are experiencing problems with the quality of your display or have a blank screen, please
press the progressive scan button to switch output mode.
Cannot record • The TV channel you want to record is not saved yet, or you have chosen wrong channel
number.
• Please check the saved channels.
• The disc is write protected. Remove the written protection or change a disc.
• The disc is a closed DVD+R or DVD-R disc. Change a disc.
• TV system mismatch. Please make sure the disc has not been recorded in different video
format (e.g. PAL or NTSC). The Multimedia Recorder does not support recordings of
different video format on the same DVD+R/RW disc.
• The disc you use may not conform to the DVD+R/RW or DVD-R/RW standards.
• The recorder does not record to CD-R/RW or DVD-RAM discs.
• Please make sure the disc has not been used in a computer before.
Time recording
does not work • The date or time is not correctly set, please check the date and time.
• The time schedule is not correctly set, please check the time schedule.
• The disc is locked. Unlock the disc.
• The disc is a closed DVD+R or DVD-R disc. Change the disc.
DVD±RW disc
cannot be edited • The disc is locked. Press the DVD button on the remote control and select Unlock Disc to
unlock the disc.
TV signal has
picture or
sound
interference • Check the aerial.
• Check the selected TV system in the system menu. In mainland Europe, the TV system
should be PAL or SECAM.
Distorted picture
or black and
white picture • The disc's colour system does not match the TV's colour system.
• The signal is not a colour signal.
No digital audio
output • Check whether the digital input connectors match the external instruments' output
connectors.
ENGLISH