Allied Telesis AT-S68 - Manual (Page 21)

AT-S67 and AT-S68 User’s Guide
21
Displaying Port Status
To display the status of the ports on an AT-FS7000 Series Switch, perform
the following procedure:
1. From the Main Menu, type 1 to select Port Menu. The Port Menu
shown in Figure 3 on page 18 is displayed.
2. From the Port Menu, type 4 to select Port Status. The Port Status
window in Figure 5 is displayed.
Figure 5 Port Status Window
The information in this window is for viewing purposes only. To change
these parameters refer to Configuring Port Parameters on page 18.
The parameters are described below:
Prt
The port number on the switch. For an AT-FS7016 port numbers will
range from 1 to 16. For an AT-FS7024 port numbers will range from 1 to
24.
Link
The status of the link between the port and the end-node connected to
the port. Possible settings are Up and Down. Up indicates that a valid
link exists between the port and the end-node. Down indicates that the
port and the end-node have not established a valid link.