Allied Telesis AT-S68 - Manual (Page 15)

AT-S67 and AT-S68 User’s Guide
15
Using the
Terminal
Interface
If you are using a DEC VT00 or ANSI (the default) terminal configuration,
refer to the table below for instructions on how to move through the
menus and select menu options.
When you press to select a field in which you can enter a value,
the -> symbol is displayed. For example:
Select Chip Number [1-2] ->
The -> symbol indicates that you can enter a new value for the
parameter or change the existing value. Once you have entered a value,
press . Parameter changes are immediately activated on the
AT-FS7000 Series Switches.
Quitting from a
Local Session
To quit a local session type Q for Quit. You should always be sure to exit
from a management session when you are finished managing the
switch. This will prevent unauthorized changes to the switch’s
configuration should you leave your workstation unattended.
Note
A local management session will automatically time-out if there has
been no management activity after the time-out value has expired.
If a local session times out, you will need to log in again. The time-
out value is not configurable and is factory set to 10 minutes.
When directed to You must
Enter your selection Type the menu option number or
letter.
Enter information (for
example, entering a port
number) Type the information and press
.
Return to previous menu Select R for Return to Previous Menu
or press .