Allied Telesis AT-CV5001 - Manual (Page 64)

Chapter 3: Removing or Replacing Line Cards or Power Supply Modules
64
Removing or Replacing Media Converter Line Cards
All of the Converteon media converter line cards are hot-swappable and
can be removed or installed while the chassis is powered on.
To remove or replace a media converter line card, perform the following
procedure:
Caution
Be sure to observe all standard electrostatic discharge (ESD)
precautions, such as wearing an antistatic wrist strap, to avoid
damaging the device. A line card can be damaged by static
electricity.
1. Label and disconnect the network cables from the card.
Figure 30. Labeling and Removing the Network Cables
AT-CM302
LK AT
T
X
RDY
LK AT FD
T
X
M
M
R
X
LPM
10/100/1000
SML ML O AM 100M
AT-CM302
LK AT
T
X
RDY
LK AT FD
T
X
M
M
R
X
LPM
10/100/1000
SML ML O AM 100M
AT-CM302
LK AT
T
X
RDY
LK AT FD
T
X
M
M
R
X
LPM
10/100/1000
SML ML O AM 100M
AT-CM302
LK AT
T
X
RDY
LK AT FD
T
X
M
M
R
X
LPM
10/100/1000
SML ML O AM 100M
AT-CM302
LK AT
T
X
RDY
LK AT FD
T
X
M
M
R
X
LPM
10/100/1000
SML ML O AM 100M
AT-CM302 slot 12
A T-CM302 slot 12
1663