Allied Telesis AT-CV5001 - Manual (Page 49)

AT-CV5001 Media Converter Chassis Installation Guide
49
3. Set the card’s DIP switches to set the operating mode and, in the case
of an AT-CV Card, the operating configuration of the 10/100Base-TX
twisted pair port. For descriptions of the operating modes, refer to the
AT-S73, AT-S99, and AT-S102 Management Software User’s Guide.
For instructions on how to set the DIP switches, refer to Installation
Guide that comes with the card.
4. Locate the top and bottom alignment guides inside the line card slots.
Figure 20. Alignment Guides
5. Align the line card with the top and bottom alignment guides located
inside the slot.
6. Slide the line card into the slot, as shown in Figure 21, until the front of
the card is flush with the front of the chassis.
7 8 6 9 10 11 12 13
290
Alignment Guides
Alignment Guides