Allied Telesis AT-CV5001 - Manual (Page 57)

AT-CV5001 Media Converter Chassis Installation Guide
57
Powering On an AC Powered Chassis
This section describes how to power on an AC powered AT-CV5001
Chassis.
To power on an AC powered chassis, perform the following procedure:
1. Select the power cord for your region: North America, United Kingdom,
Europe, or Australia.
2. Plug the power cord into the AC power connector on the rear of the
chassis, as shown in Figure 26.
Figure 26. Connecting the AC Power Cord
3. Plug the other end of the power cord to an appropriate power outlet.
If the chassis has two AT-CV5001AC Power Supplies, repeat this
procedure to power on the second module.
Refer to “Technical Specifications” on page 79 for the power
requirements.
Note
If the chassis has two power supplies, you can protect the unit from
a power circuit failure by connecting the two power supplies to
power sources that are operating on different power circuits.
A
AT-CV5001A
C
DISCO NNECT ALL P OWER SUPP LIES &
REFER TO M ANUAL BEFO RE SE RVICIN G.
100-2 40V AC~
1646