Allied Telesis AT-CV5001 - Manual (Page 38)

Chapter 2: Installation
38
Installing the AT-CV5001AC Power Supply
The AT-CV5001AC Power Supply can be installed in either power supply
slot on the read panel.
Note
The AT-CV5001 Chassis can contain two power supplies. The
power supplies can be of the same type (AC or DC) or different
types (AC and DC).
Note
The power supply module is hot-swappable. If the chassis already
has a power supply that is powered on, you do not have to power off
the unit to install the new power supply module.
To install the AT-CV5001AC Power Supply, perform the following
procedure:
1. Remove the AT-CV5001AC Power Supply from its shipping package
and store the package in a safe place.
Note
You must use the original package if you need to return the unit to
Allied Telesis.
2. Verify the package contents, listed in Table 3.
Table 3. AT-CV5001AC Power Supply Components
One AT-CV5001AC Power Supply
AT-CV 5001A C
DISCO NNECT ALL P OWER SUPP LIES &
REFER TO M ANUAL BEFO RE SE RVICIN G.
100-24 0VAC ~
1688