Alliance Laundry Systems D677I User Manual

Page 20

Installation

510969

Step 3: (Gas Dryer Only) Connect Gas

Supply Pipe

For further assistance, refer to section on Gas
Requirements.

1. Make certain dryer is equipped for use with the

type of gas in laundry room. Dryer is equipped at
the factory for Natural Gas with a 3/8" N.P.T.
gas connection.

2. Remove the shipping cap from the gas

connection at the rear of the dryer. Make sure
you do not damage the pipe threads when
removing the cap.

3. Connect to gas supply pipe.

4. Tighten all connections securely. Turn on gas

and check all pipe connections (internal &
external) for gas leaks with a non-corrosive leak
detection fluid.

5. For L.P. (Liquefied Petroleum) gas connection,

refer to section on Gas Requirements.

Figure 11

D233I

New Stainless Steel Flexible Connector –
Use only if allowed by local codes
(Use Design A.G.A. Certified Connector)

Black Iron Pipe
Shorter than 20' (6.1 m) – Use 3/8" pipe
Longer than 20' (6.1 m) – Use 1/2" pipe

1/8" N.P.T. Pipe Plug
(For checking inlet gas pressure)

3/8" N.P.T. Gas Connection

Equipment Shut-Off Valve – Installed within 6'
(1.8 m) of dryer

D233I