Agilent Technologies Switch/Measure User Manual
Page 144
132
34980A User’s Guide
4
Low Frequency Multiplexer Switch Modules
34925T-001 Terminal Block for Two- or Four-Wire Mode
This terminal block with screw- type connections is labeled with the
model number and the abbreviated module name. In addition, space is
available on the label for you to write the slot number.
The 34980A Product Reference CD (shipped with the instrument)
contains a the 34925T (2- wire mode) Wiring Log for you to document
your wiring configuration for this module. You can open the wiring log
file in Microsoft® Excel® or Adobe® Acrobat® format.
N O T E
All modules that connect to the internal DMM are interlock
protected. This means that when an installed module is exposed (no
terminal block or cable is connected), the Analog Bus relays are
open and disconnected from the Analog Buses. See
for
further information.
N O T E
If you are using an Agilent terminal block to connect your DUT to
this module be sure to use the 34925T-001 terminal block that
corresponds to the 2- or 4-wire configuration mode. An error will
not be generated if you have installed a terminal block that doesn't
match the present module configuration.