Agilent Technologies Switch/Measure User Manual
Page 141
Low Frequency Multiplexer Switch Modules
4
34980A User’s Guide
129
• using the *RST command. This command resets the mainframe and all
installed modules to the Factory configuration. This affects all
installed modules.
• cycling system power. This affects all installed modules.
If the overvoltage situation is not resolved, clearing the overvoltage will
result in a new overvoltage event occurring immediately.
Further FET protection is assured only as one channel in each bank is
closed at any time. Thus this module will operate as only a 1:N MUX
module. For more information about FET channel closures, refer to
.